A key component for your JBD tube. The Snap-N-Pull Downstem or Sleeve is a hand-cut and flared borosilicate glass tube with a rubber seal; the tube of glass that joins the bowl and the water within the bubble of the Tube.
Current Regular 19mm Pixie downstems, Keiki and Pixie downstems (3.0 inches, 3.5 inches, 4.0 inches, 4.5 inches), LE Downstems (5.0 inches, 5.5 inches, 6.0 inches) and Mothership Downstems (6.5 inches, 7.0 inches)
Preop (pre 2003) 14mm
We can provide a downstem shorter or longer upon request!
**please note: due to the handmade quality of our tubes, your downstem might not fit these parameters please see below for instructions on how to measure for your tubes perfect downstem.
How to Measure your downstem length:
Step 1: Ensure your JBD Tube is clear of all Ancillary hardware (old downstem, and bowl)
Step 2: take an item similar to a chopstick and slide it into your JBD tube's downstem hole, until it is submerged in the water of the bong to your desired depth. (JBD tip: you want it all the way to the back/bottom WITHOUT TOUCHING the glass.)
Step 3: where the item exits the bong you are going to want to make a mark. This measurement from tip to mark (in inches) is the length of your downstem.
Step 4: Hit Check Out and In your Cart under Special Notes, Type the exact length in inches.
Choosing a selection results in a full page refresh.
Press the space key then arrow keys to make a selection.